BMW Engine Mount Failure: Symptoms, Causes & Replacement Cost

Image: BMW X1 Series Rear Engine Mount Support for £113.04 at mtautoparts.com

Image: BMW X1 Series Rear Engine Mount Support for £113.04 at mtautoparts.com 


If your BMW has started to shake at idle, especially sitting in Drive at the lights, check the engine mounts before anything else. They're a common wear item on higher-mileage F- and G-generation cars. They're often mistaken for an engine fault, and they're far cheaper to fix.

What BMW engine mounts do

The engine sits on two mounts, one on each side, bolted to the front subframe. A third mount supports the back of the gearbox. That's the layout on most rear-wheel-drive models. Front-wheel-drive cars with a transverse engine use a different arrangement.

Most of these cars use hydraulic mounts. They're filled with fluid that moves between internal chambers as the engine rocks, which damps vibration far better than plain rubber. The catch is that once the fluid leaks out, the mount goes soft and stops doing its job.

Three-cylinder engines are the most sensitive. They have a natural rocking motion that four- and six-cylinder engines don't, so even slightly tired mounts let you know about it.

Symptoms of a worn BMW engine mount

Vibration at idle. The most common sign. You'll feel it through the steering wheel and seat, usually worst in Drive with your foot on the brake. If it smooths out once you're moving, mounts are the likely cause.

A clunk on take-up. A knock when you select Drive or Reverse, or when you get back on the throttle after lifting off, means the engine is moving further than it should.

Visible movement. Open the bonnet and have someone hold the car on the footbrake in gear while they raise the revs slightly. A healthy engine barely shifts. On worn mounts, it rocks or lifts.

Leaks or sagging. Look under each mount for a damp, oily film. That's the hydraulic fluid escaping. A collapsed mount can leave the engine sitting lower on one side, and you may find hoses or the fan cowl rubbing.

Check this first: A misfire, a worn gearbox mount, a failing dual-mass flywheel or a sticking EGR valve on a diesel can all feel similar. Have the engine scanned for fault codes before buying mounts.

Why they fail

Age is the main cause. The rubber hardens and cracks, and hydraulic mounts lose their fluid over time. Heat makes it worse, so the mount on the hot side of the engine, near the exhaust and turbo, usually has the harder life.

Oil leaks are the other common culprit. Engine oil softens rubber, so a long-running weep from the valve cover or oil filter housing gasket, both familiar BMW faults, can finish a mount early. Fix the leak when you replace the mounts, or the new ones will go the same way.

Driving style plays a part too. Hard launches, rough gear shifts, and remapped engines with extra torque all load the mounts harder, so a well-used M140i or 335d is likely to need them sooner than a gently driven 320d.

BMW engine mount replacement cost

Used BMW engine mounts cost roughly £100 to £300+ per mount depending on the part and the car’s model. Genuine new BMW parts sit at the top of that range. Lemförder and Corteco, both original-equipment suppliers to BMW, cost less and are a good choice. Avoid cheap unbranded hydraulic mounts: they're often harsher and won’t last.

Labour is usually one to three hours per mount, depending on the car. On some models, the engine has to be supported from above and the fan cowl or parts of the exhaust removed for access. The average independent garage rate is about £75 an hour, so expect to pay around £150 to £450 per mount at an independent. Main dealers charge more.

Replace the mounts as a pair. If one has failed, the other has covered the same miles and won't be far behind. Ask the garage to check the gearbox mount at the same time.

If your BMW needs a replacement engine, fit new mounts while it's out. The extra labour is minimal for that. MT Auto Parts sells used engines and gearboxes from F, G and U generation BMWs, with the donor car's mileage and condition shown on each listing and a 30-day warranty on almost all parts.

Frequently Asked Questions

How long do BMW engine mounts last?

BMW doesn't give a replacement interval. Many last beyond 60,000 miles, but heat, oil leaks and hard driving can shorten that a lot. On a higher-mileage car, have them checked whenever it's on a ramp.

Can I drive with a broken engine mount?

For a short, gentle trip, usually yes. A failed mount lets the engine move more, which strains the other mount, the gearbox mount, hoses and exhaust. If it clunks heavily under acceleration, get it checked before going further.

Should I replace both engine mounts?

Yes, in almost every case. Pairing a new mount with a worn one can leave the engine sitting unevenly and wear the new part faster.

Are aftermarket mounts as good as genuine BMW?

From an original-equipment supplier such as Lemförder or Corteco, yes. From an unknown brand, it might be a gamble.

Disclaimer: This article is for general information only. Costs are indicative estimates based on typical rates and published parts prices, and will vary by model, region and workshop. Have any vibration or noise diagnosed by a qualified BMW specialist before replacing parts.

Popular posts from this blog

BMW M57 Engine: Every Model That Has It (And Why It's So Reliable)

BMW Diesel Engines Ranked: The Most Dependable Options for UK Drivers

What Are Common BMW B57 Engine Problems?